Hisun Axis 700 MAGNUM REVOLUTION-PRO ATV Speed (2024)

Description

Do away with the stock rev / speed limitations and Amplify the speed and the Performance of your Hisun Axis 700. This insane REV-PRO ATV Rev Limiter simply plugs into the ECU’s crystal oscillator soldered onto the Engine Management board which supplies the oscillating signal for Electronic Control Module’s operation. With two push buttons you can increase or decrease the stock RPM limit in a range of + / - 20%. RPM limit adjustment is accomplished by a microcontroller that is able to efficiently alter the RPM in increments of 20 1/min. CDI Box overrides the Powertrain Control Module’s vibration frequency. TO DECIDE YOU CAN INSTALL THIS PART PLEASE ACKNOWLEDGE IT IS IMPORTANT TO LEARN ABOUT THE HIGH NOTES TIPS PDF ABOUT YOUR Hisun Axis 700 Performance CDI.

This brilliant programmable Hisun Axis 700 Rev Limiter provides more precise control over ignition timing and in tandem with the Rotational speed limit than stockEngine Management software. The restrictive factory rev limiter on fuel injected ATV’s is a setting pre-programmed in the Electronic Control Unit to restrict its max - revolution. This is in general implemented to prevent any damage to the motor. Simply put, Rev Box is exerted to hold back the engine from reaching the max rev at which it develops the most HP physically. This might be useful in a rental All Terrain Vehicle but very frustrating when fitted to racing or upgraded ATVs. The stock RPM Governor works by interrupting the firing that is distributed to the plugs, to hinder the engine from operating above a pre-programmed rotational speed referred to as the red line limit.

This Rev Limiter is intended to fool the factory rev governor and Enhance the overall Power Potential of your Hisun Axis 700. It eliminates the stock rpm limiter in order to conduct higher top end. Our firm’s ATV specific Rev-Pro Rev Governors are sorted into numerous categories according to the Engine Computer type, stock Engine Management’s oscillation frequency range, etc. This Best Quality Upgrade is available to all All-Terrain-Vehicles controlled by Power Control Module.

As an important favorable side effect, Magnum Tuning’s Hisun Axis 700 Performance CDI Box accelerates the injection timing that can only be exploited if the fuel maps is remapped as well. Beside to the hopes for higher rev, a Engine Management Chip is a must, In tandem with this Rev Limiter to Pull Up the Power Potential and carry out the top vigor with fine throttle sensitivity.

Our Rev Pro Ignition Hisun Axis 700 Performance CDI will bring your UTV’s Power Output steps higher. Our Rev Governor raises the stock Rev limit by 20% for optimum Output. Check out the specs and keep in mind that the Performance CDI Box you will receive have been specifically developed to fit for your Hisun Axis 700’s engine. Magnum’s Rev Pro RPM Governor is known for producing more Power Output out of All-Terrain-Vehicle engines.

The top revs is where the spark is being arrested at a fixed rev. Revolution-Pro Hisun Axis 700 RPM Governor can be set quickly and easily to reach higher rotational speed range than the stock to hoax the factory top end speed limit. Your Four-Wheeler would remain sluggish without the remap of the fuel injection settings if it has to work around or over the top RPM. A Engine Computer Tune is a must have when it comes to bypassing the stock rev limiter. Stay with us to capitalize your knowledge about the HP-Tune Upgrades available for your Hisun Axis 700. On pumped up Quads where the power plant revs up to red line limit easy, the increased Rotational speed limit will allow for unbridled Power Output and added - torque.

Our fully adjustable Hisun Axis 700 Rev Limiter Bypass neither affects engine reliability nor service life, unless you are racing or over-extending your ATV’s motor. This Impeccable Magnum Tuning Part is governed by the adjustable Voltage-Controlled Crystal Oscillator (VCXO) that is able to set extended frequency range, and apt to fool the restrictive stock rev limiter and in par the speed limiter in order to allow you to Drop the stock rev and speed limitations.

Specs

Claims

(fuel controller recommended)

• Adjustable 0 up to 20% RPM increase.
• higher top speed if fuel trim remapped
• Up to 8% gain in HP and torque if fuel trim remapped
• improved acceleration and throttle response
• advanced ignition timing

Features

• Push button, on-the-fly programming
• Precise 20 RPM adjustment steps
• 10-year warranty

Packing List

• 1 x REV-PRO unit
• 2 x bullet terminal
• 2 x zip tie
• 1 x fork connector
• 1 x heat shrink tubing
• 1 x flexible cable gland
• 1 x detailed installation instructions